Dosing Guide — 2026-10-28
Wolverine 10mg is the entry size of our most popular recovery blend — 5mg of BPC-157 plus 5mg of TB-500 in one vial. It's the lower-commitment way to run the Wolverine Stack, ideal for a first cycle or a shorter research design. This guide covers what's in the vial, how to mix it, the daily protocol, and how long it lasts. For laboratory research use only.
Pricing and the batch COA are on the Wolverine 10mg page, and the exact numbers are in the Wolverine 10mg dosing guide. For the deeper protocol discussion — cycling, site selection, the GHK-Cu add-on — the Wolverine Stack dosing guide has it all.
Wolverine 10mg is a pre-blended combination: 5 mg BPC-157 + 5 mg TB-500 in one lyophilized vial. BPC-157 is studied for localized tissue repair and TB-500 for systemic recovery signaling — together they cover both angles, which is why the stack is a recovery-research staple. For the rationale behind the pairing, see the Wolverine Stack explained.
The standard dose is 250 mcg of each compound once daily. On the 10mg vial that's a clean 10-unit pull:
| Protocol | Dose | Units (U-100 syringe) |
| Standard | 250 mcg BPC + 250 mcg TB | 10 units |
| Aggressive recovery | 500 mcg BPC + 500 mcg TB | 20 units |
Injected subcutaneously, once daily, ideally near the area being targeted where practical.
Add exactly 2 mL of bacteriostatic water:
Inject the water down the vial wall, swirl gently — never shake — and refrigerate once dissolved. You'll need bacteriostatic water. If you're weighing this against the bigger vial, the 10mg vs 20mg comparison lays out the trade-off (same dose, the 20mg just lasts twice as long).
A 10mg vial covers a few weeks of daily dosing:
| Protocol | Approx. duration per vial |
| Standard (10 units/day) | ~20 days |
| Aggressive (20 units/day) | ~10 days |
A typical 6-week cycle uses about two 10mg vials — which is exactly why researchers planning a full cycle often step up to the Wolverine 20mg vial, since one of those covers the same cycle. The 20mg stack dosage guide runs the full cycle math.
The Wolverine Stack handles extended cycles well, with minimal receptor-desensitization concern. Common structures are 6 weeks on / 4 weeks off for general recovery, or 8–12 weeks for tendon and ligament research. Because BPC-157 acts locally, injecting near the target tissue matters for site-specific designs; TB-500 works systemically no matter where it's injected.
Refrigerate the dry powder before mixing. After reconstitution, store at 2–8°C and use within about four weeks. Avoid freeze-thaw cycles.
Sub-milligram dosing only works with an accurately filled, pure vial. Every Wolverine 10mg vial from Platinum Biolabs ships with a batch-matched COA at 99%+ HPLC purity, handled from a US facility. Code PLATINUM25 takes 25% off at checkout. Planning a full cycle? The Wolverine 20mg vial is the more economical choice per milligram, and the Wolverine Repair Stack adds GHK-Cu for matrix-remodeling research.
Disclaimer: All information presented in this article is for educational and informational purposes only. Platinum Biolabs does not promote or endorse the use of peptides for human consumption. All products sold by Platinum Biolabs are intended strictly for laboratory and research use only. Consult a qualified healthcare professional before making any health-related decisions.