DSIP Dosage Guide: Reconstitution, Units, and Pre-Sleep Timing

Dosing Guide — 2026-11-18

DSIP (delta sleep-inducing peptide) is a niche peptide studied for sleep and stress-response research. It's dosed once nightly before bed, and timing matters more than almost anything else. This guide covers reconstitution, the nightly dose in syringe units, and cycling. The numbers match our DSIP protocol page.

::shop dsip-10 bac-water-10

Reconstitution math

Standard reconstitution: add 3 mL bacteriostatic water to the 10 mg vial (fill to the 3 mL mark — the vial's capacity).

MetricValue
Peptide10 mg
Bac water3 mL
Concentration3.33 mg/mL
Per unit~33 mcg

So 100 mcg = 3 units, 200 mcg = 6 units, 300 mcg = 9 units, 500 mcg = 15 units on a U-100 syringe.

Dosing

LevelDoseUnits
Conservative / light100 mcg3 units
Standard200 mcg6 units
Aggressive (less common)300–500 mcg9–15 units

Start at 100 mcg and titrate up by response. Take it 30–60 minutes before intended sleep time.

Administration

Subcutaneous, into pinched abdominal skin, on a consistent pre-sleep schedule. Timing matters more than site here — dose at the same point before bed each night.

Cycling

ParameterValue
Cycle length2–4 weeks on
Time off~2 weeks between blocks

DSIP is typically run in short cycles, not continuously long-term.

Important research note

There is no validated human dose for DSIP — the ranges here are a commonly cited research convention, not a proven protocol. DSIP sold by Platinum Biolabs is for laboratory and research use only. For mixing technique, see the reconstitution guide. Refrigerate after reconstitution and use within 4 weeks.

Disclaimer: All information presented in this article is for educational and informational purposes only. Platinum Biolabs does not promote or endorse the use of peptides for human consumption. All products sold by Platinum Biolabs are intended strictly for laboratory and research use only. Consult a qualified healthcare professional before making any health-related decisions.

Shop Research Peptides